Charging the battery
Introduction
To be continued on next page
31
Charging the battery
Introduction
You cannot use the battery immediately after shipment. The battery can be used after charging it with the designated charger. Be sure to charge it
before use. The battery can be used when the LED on it turns on.
Proper use of the battery
Charging can be carried out at any time regardless of the amount of charge remaining, but you should fully charge the battery in the
following cases. Be sure to use the designated charger to charge the battery.
•
The battery is uncharged at the time of shipment. Before riding, be sure to charge the battery until it is fully charged.
•
If you will not use the bicycle for an extended period of time, charge the battery before storing the bicycle.
If the battery has become completely discharged, charge it as soon as possible. If you leave the battery uncharged, the battery may
deteriorate.
•
If you will not ride the bicycle for an extended period of time, charge the battery periodically. Do not let the battery discharge completely.
Charging the Battery
1
Attach the charger plug to the charger
connector (B) of the battery (A).
Insert it with the groove (C) side of the
plug facing the direction shown in the
illustration.
<BT-E6000>
(B)
(C)
(A)
(D)
<BT-E6010>
(C)
(B)
(A) Battery
(B) Charger connector
(C) Groove
(D) Back side (No groove)
To Next Page
Loading...
