Shimano Steps SC-E6000 - Installing the Ferrite Core (DU-E6001)

Installing and wiring the drive unit
Installing the ferrite core (DU-E6001)
23
 Installing the ferrite core (DU-E6001)
If a ferrite core is included with DU-E6001, install it by following the procedure described below.
Depending on the specifi cations, a ferrite core may not be included with DU-E6001, so installation is not required.
1
Install the ferrite core (A) on the power
cord (B).
(A)
(B)
(A) Ferrite core
(B) Power cord
2
Make sure that the power cord is not
pinched and fi rmly secure the ferrite
core.
Then, fi x the ferrite core with the zip tie
(C).
(C)
(C) Zip tie
NOTE
• Check that the ferrite core tabs are
fi rmly secured.
• Do not cut off the excess portion
of the zip tie. The cut surface of
the zip tie may scratch the cable or
case.
• Do not drop the ferrite core or
subject it to any shocks. Subjecting
the ferrite core to shocks will
cause it to break or crack,
rendering it unusable.
3
Position the ferrite core so that the
power cord fi ts inside the drive unit.
(a) For SM-BME60
(b) For SM-BME61
(a)
(b)