Installation
Installing the battery mount
16
SM-BME61
1
Attach the mount lower case (E) to the
mounting holes in the frame, insert the
mount fixing bolts (C) into the washers
(D), and secure the case using the bolts.
Then, temporarily attach the key unit (B)
with the key unit fixing bolts (A).
(A)
(D)
(B)
(E)
(C)
(A) Key unit fixing bolt (M5)
(B) Key unit
(C) Mount fixing bolt (M5)
(D) Washer
(E) Mount lower case
Tightening torque:
3 N·m
{27 in. lbs.}
2
Adjust the position of the key unit to
allow a clearance of 223 mm between (a)
and (b) shown in the illustration.
Temporarily attach the key unit cover
and perform adjustment to make sure
that the battery can be smoothly
connected and disconnected and no
noise will be produced due to looseness
during traveling. Then, fully tighten the
key unit fixing bolts.
223mm
(a)
(b)
Tightening torque:
3 N·m
{27 in. lbs.}
3
Fully tighten the key unit cover fixing
bolts (J) to attach the key unit cover (I).
Insert the plug (F) into the mount lower
case. Insert the plug between the mount
upper case (G), and secure them using
the mount upper case fixing bolts (H).
(G)
(H)
(F)
(J)
(I)
(F) Plug
(G) Mount upper case
(H) Mount upper case fixing bolt (M3)
(I) Key unit cover
(J) Key unit cover fixing bolt
(M4)
Tightening torque:
0.6 N·m
{5.3 in. lbs.}
To Next Page
Loading...
