Installing and wiring the drive unit
Connecting the light adapter to the drive unit
26
2
Remove the dummy plug (C) from the
drive unit with TL-EW02.
(C)
(C) Dummy plug
3
Attach the connector of the light
adapter to the drive unit.
4
Pass the front light and tail light cables
through the cable holes (D) shown in the
illustration and attach the cover.
Tighten the cover fixing bolts (E) in the
three locations.
(E)
(D)
(D) Cable holes
(E) Cover fixing bolt (M3)
Tightening torque:
0.6 N·m
{5.3 in. lbs.}
5
Fix the light cables to the electric wire
around the light adapter and route them
along the frame.
(G)
(F)
(F) Front light cable
(G) Taillight cable
For information on compatible lights, contact
a manufacturer of completed bicycles.
To Next Page
Loading...
