How do I troubleshoot an abnormality in the Shimano Steps Bicycle Accessories drive unit?
If an abnormality is detected in the drive unit of your Shimano Steps Bicycle Accessories, turn the power off and then on again, referring to the SHIMANO STEPS user's manual. If the error persists, stop using it and contact your place of purchase or a distributor for assistance.
What causes an abnormal speed signal on Shimano Steps Bicycle Accessories?
If an abnormal vehicle speed signal is detected from the speed sensor on your Shimano Steps Bicycle Accessories, have your place of purchase perform the following: * Install the speed sensor and magnet in the appropriate locations. * If the bicycle has been modified, return it to the factory default setting. After following these instructions, ride the bicycle for a short while to clear the error. If the error persists, contact your distributor for assistance.
How to fix Shimano Steps Bicycle Accessories when no speed signal is detected?
If no vehicle speed signal is detected from the speed sensor on your Shimano Steps Bicycle Accessories, have your place of purchase check the following: * Install the speed sensor in the appropriate location. * Install the magnet in the appropriate location. (Refer to the "Disc brake" section in "General operations" or to the STEPS series dealer's manual for how to install the removed magnet.) If the error persists, or if the information above does not apply, contact your distributor for assistance.
What to do if Shimano Steps Bicycle Accessories power keeps disconnecting?
If you are experiencing unexpected power disconnections with your Shimano Steps Bicycle Accessories, turn the power off and then on again, referring to the SHIMANO STEPS user's manual. If the issue persists, have your place of purchase check the following: * Ensure the battery mount is secure and doesn't rattle. * Inspect the power cord for damage and replace if necessary.
General| Max Torque | 85 Nm |
|---|---|
| Connectivity | Bluetooth, ANT+ |
| Firmware update by E-TUBE PROJECT | Yes |
| Waterproof rating | IPX5 |
| Position | Handlebar-mounted |
| Compatibility | Shimano Steps E6100 and E8000 series |
| Mounting | Handlebar clamp |
Guidelines for safe operation, handling, and disposal to prevent injury and damage.
Explanation of manual organization and identification of cycle computer and switch unit parts.
Understanding operational notation and procedures for installing the cycle computer.
Information on how to install and remove the cycle computer from the bicycle.
Procedure for powering the cycle computer and linked bicycle components on and off.
Explanation of icons and data displayed on the cycle computer's main screen.
Understanding the icons used to show the remaining battery charge.
How to cycle through different data fields like speed, distance, and time on the display.
Steps to enter, navigate, and exit the cycle computer's configuration menu.
Configuring clock, operational sounds, screen brightness, language, and units.
Customizing light, start gear position, and riding comfort profiles.
Fine-tuning the gear shifting timing for automatic gear shifting.
Details on 2.4 GHz, ANT, and Bluetooth LE connection types and system specifications.
Using the E-TUBE PROJECT software for settings and firmware updates.
Solutions for RD protection, gear shifting, and other operational problems.
Interpreting and resolving system warning codes and their restrictions.
Understanding and resolving system error messages and their remedies.
A summary guide for symptoms, possible causes, and remedies for common issues.
To Next Page
