34
Walk assist mode
•
This mode may not be available in certain regions.
•
The walk assist function operates at a maximum of 6 km/h. During electronic gear shifting, the assist level and speed are
controlled by the gear position.
•
If Assist-Y is not pressed for at least one minute, the system will restart in the mode that was set prior to setting [WALK]
mode.
•
The intelligent walk assist function activates when an electric shifting system such as XTR, DEORE XT SEIS is connected.
System individually supplies assist power to detect gear position.
"Intelligent walk assist" support rider more torque output in steep climb condition in lower side gears.
"Quick walk assist" function works quickly by holding down SW from any mode.
Switch to walk assist mode
1.
Press and hold Assist-Y (about 2 seconds) until the
following occurs.
SC-E6100/SC-E7000: [WALK] is displayed on the screen
EW-EN100: LED lamp (inner side) lights up blue
Assist
2 Sec.
NOTE
A warning tone will sound while switching is in progress if it is
not possible to switch to [WALK] mode because the current
speed is not [0 km/h] or there is pressure on the pedals etc.
< SC-E6100 >
< SC-E7000 >
< EW-EN100 >
LED lamp (inner side)
Assist OFF Walk assist mode enabled
To Next Page
Loading...
Need help?
General
