37
Clearing the traveling distance
You can clear the traveling distance in the main screen. When the traveling distance is cleared, [TIME] (travelable time),
[AVG] (average speed), [MAX] (maximum speed) are also cleared.
This operation can only be used when SW-E6010 is being used.
1.
Press Assist-A to change the travel data display to [DST].
Assist
2.
Press and hold down Assist-A until the value below the
[DST] display blinks.
3.
Press Assist-A again.
•
Travel data is cleared.
•
The [DST] value stops blinking and the screen takes
resets to the basic screen after being left alone for 5
seconds.
To Next Page
Loading...
Need help?
General
