38
Installation/removal
Securing the BC-9000 cable
1. Install the brake shoe to the rim surface as shown in the figure.
Direction of rim rotation
Toe-in 0.5 mm
5 - 7 N·m
Shoe fixing screw
1 mm or more
NOTICE
• Use brake shoes that are appropriate for the rim type and rim outer width. For
details, refer to the “Recommended tire size / rim outer width / brake shoe”
section.
Securing the BC-9000 cable
WARNING
• When an inner cable is passed through the outer casing, be sure to wipe the fixing
section of the inner cable before securing the cable. Residual grease in the area of the
clamp screw may prevent sufficient holding force.
NOTICE
• Be careful not to let the BC-9000 inner cable come into contact with the shifting lever
or the metallic part (adjustment section) of the caliper brake. If the coating of the
cable gets abraded during installation, it may develop a fuzzy appearance, although
this will not affect performance.
To Next Page
Loading...
