Shimano Non Series User Manual

11
Installation/removal
Installing the dual control lever
Installation/removal
Installing the dual control lever
1. Turn over the bracket cover from the front side.
Gently turn over the ends of the bracket cover with both hands and slowly push them
down.
NOTICE
• Forcibly pulling it may cause damage to the bracket cover because of its material
properties.
2. Loosen the clamp screw and pass the clamp band over the handlebar.
Clamp screw
Clamp band

Shimano Non Series Specifications

General

Brand	Shimano
Model	Non Series
Category	Controller
Language	English