9
TO ENSURE SAFETY
• For maximum performance we highly recommend SHIMANO lubricants and maintenance
products.
For installation to the bicycle and maintenance
• Use an outer casing / electric wire which still has some length to spare even when the
handlebars are turned all the way to either side. Furthermore, check that the dual control
levers do not touch the bicycle frame when the handlebars are turned all the way.
• Use the parts indicated in the part breakdown of the dual control levers when you
replace the clamp band, clamp screw, or clamp nut.
• Even with the recommended tightening torque, there is a possibility that the carbon
handlebars may become damaged and insufficiently tightened. Confirm the appropriate
torque value with the bicycle manufacturer or the handlebar manufacturer.
Dual control lever
• Dummy plugs are installed at the time of shipment from the factory. Do not remove
them except when necessary.
• When routing the electric wires, take care to ensure that they do not interfere with the
brake levers.
Satellite shifter
• When connecting electric wires, make sure that foreign matter does not get inside the
plug or satellite shifter connection port. A connection with foreign matter present may
result in a malfunction.
• If the plug is exposed during storage, transportation, or maintenance work, and there is
a possibility of foreign matter getting inside, protect the plug with masking tape or a
similar material.
• If you do not feel a click when connecting an electric wire, check that there is no foreign
matter inside the plug or satellite shifter connection port. If foreign matter is present, use
a blower to remove it. If the problem persists, replace the satellite shifter with a new
one.
The actual product may differ from the illustration because this manual is
intended mainly to explain the procedures for using the product.
To Next Page
Loading...
Need help?
General
