SHOWTEC Creator 1024 - Patch Utilities Functions

13
Creator 1024
Ordercode: 50730
4.2.3 Patch Utilities
Invert
Allows you to invert an attribute of a fixture, so when you set zero the output will be full. You cannot invert
some attributes.
1) If not in the Patch menu, press <Patch> to enter.
2) Press <D>[Patch Utilities]. Then, press <B>[Set Invert].
3) Select fixture and select attribute, then, press <C> or <D> to modify.
Set/Reset Instant mode
When the fades LTP (movement) channels between two memories, the LTP values normally change
smoothly. You can set Instant mode to make the channel snap instantly to the new value.
1) If not in the Patch menu, press <Patch> to enter.
2) Press <D>[Patch Utilities]. Then, press <C> [Set Instant Mode].
3) Select fixture and select attribute, then, press <C> or <D> to modify.
Swap pan and tilt
If you have some fixtures mounted sideways, it can be useful to swap the pan and tilt channels over.
1) If not in the Patch menu, press <Patch> to enter.
2) Press <D>[Patch Utilities]. Then, press <D> [Swop P/T].
3) Press <Up> or <Down> to view the Pan/Tilt swop info. Press the soft key to modify.