SHOWTEC Creator 1024 - Controlling Fixtures; Fixture Selection and Attribute Modification

14
Creator 1024
Ordercode: 50730
5 Controlling fixtures
5.1 Select fixtures
 Select a single fixture:
Press the handle Fixture buttons for the fixtures you want. The LED in the Fixture button comes on for
selected fixtures
 Select a range of fixtures:
To select a range of fixtures, hold down the Fixture button for the first fixture then press the Swop button
for the last fixture.
 Stepping through selected fixtures one at a time:
If you have selected a range of fixtures, our console has functions to step through the selected fixtures
one at a time. This can make it easier to program a range of fixtures because you don’t have to select
each one manually. Pressing <> or <> in “Fixture control area”, it will select the fixtures in the range
one at a time. If <HiLight> button is activated, The selected fixture from the range will light up, and the
other fixtures will go out.
 Activate previously selected fixtures:
To activate all the previously selected fixtures, press <All> in “Fixture control area”.
 Select fixtures at odd positions:
Press <Odd>, the fixtures at odd positions of the selected fixtures will keep selected, but, those at even
positions will be de-selected. This is related to the order that you selected the fixtures before pressing
<Odd>.
 Select fixtures at even positions:
Press <Even>, the fixtures at even positions of the selected fixtures will keep selected, but, those at odd
positions will be de-selected. This is related to the order that you selected the fixtures before pressing
<Even>.
5.2 Modify an attribute value
1) Select a fixture.
2) Select an attribute. Then, use <Wheel A> and <Wheel B> to adjust the value. Or, switch to Attribute
mode to adjust the attribute value by sliders.
3) To see the output values, press <Output>.
5.3 Advanced options
 Locate fixtures:
Select fixtures; Press <Locate> in “Fixture control area” to locate the fixtures. Fixture locating is
provided in the fixture library.
 Align fixtures:
Select fixtures; Press <ML> in “Fixture control area” then <A>, all the attribute values of all the
selected fixtures will be aligned to the first fixture.
 Align attributes:
Select fixtures and select attributes; Press <ML> in “Fixture control area” then <B>, the currently
selected attribute values of all the selected fixtures will be aligned to the values of the first fixture.