Shure Incorporated
11/32
1.
2.
3.
4.
5.
•
•
Installing Underneath a Table
Hold the tray in the desired location under a table.
Use a pencil to mark the location of the mounting holes on the table.
Drill 4 holes for the screws. The diameter of the holes in the tray are 7.1 mm.
Install the components into the tray.
Install with 4 screws to secure the tray underneath the table.
Connections and Signal Flow
The ANIUSB-MATRIX has 4 Dante inputs and 2 Dante outputs. You can route any input to any output and adjust crosspoint
gain using the matrix mixer.
The ANIUSB-MATRIX has 2 Dante transmit flows. Learn more about Dante flows.
Best Practices
For best results, route 1 microphone to the ANIUSB-MATRIX. If using multiple microphones in a space, use a device with
an automixer (such as a P300 or IntelliMix Room).
Use Shure Designer's auto route workflow to quickly set up Dante audio routes, mute control routes, matrix mixer routes,
and other settings.
These are some of the devices that you can connect to the ANIUSB-MATRIX:
To Next Page
Loading...
