Shure Incorporated
26/32
•
•
•
•
Using Command Strings
This device receives logic commands over the network. Many parameters controlled through Designer can be controlled using
a third-party control system, using the appropriate command string.
Common applications:
Mute
LED color and behavior
Loading presets
Adjusting levels
A complete list of command strings is available at:
pubs.shure.com/command-strings/ANIUSB-Matrix.
Reset
The reset button is located inside a small hole in the rear panel. Use a paperclip or other small tool to press the button.
There are two hardware reset functions:
Network reset (press button for 4-8 seconds)
Resets all Shure control and audio network IP settings to factory defaults
Full factory reset (press button for longer than 8 seconds)
Restores all network and Designer settings to the factory defaults.
Software Reset Options
To simply revert settings without a complete hardware reset, use one of the following options:
Reboot Device:Power-cycles the device as if it were unplugged from the network. All settings are retained when the device is
rebooted.
Default Settings: To revert audio settings back to the factory configuration (excluding Device Name, IP Settings, and Pass
words), select Load Preset and choose the default settings preset.
Troubleshooting
Problem Solution
Software lags in Google Chrome browser
Problem is browser-related. Turn off hardware acceleration
option in Chrome.
Sound quality is muffled
Use equalizer to adjust frequency response. See the equal
izer applications for the appropriate use.
Audio sounds too high or too low in pitch
Make sure that the sample rate settings for Playback and
Recording are the same in your computer's sound settings. If
To Next Page
Loading...
