Shure MXA310 - Page 61

Shure Incorporated
61/76
Command String:
< GET NUM_ACTIVE_MICS >
MXA310 Response:
< REP NUM_ACTIVE_MICS x >
where n is number of active chan
nels that takes on values: MXA310:
channels 1-4
Get Automix Channel Solo Enable
Command String:
< GET x CHAN_AUTOMIX_SOLO_EN >
where x is channel number: 0 is not
valid MXA910: channels 1-8
MXA310 Response:
< REP x CHAN_AUTOMIX_SOLO_EN ENABLE >
< REP x CHAN_AUTOMIX_SOLO_EN DISABLE >
where x is channel number: 0 is not
valid MXA910: channels 1-8; where
sts indicates channel x's SOLO
state: ENABLE DISABLE
Set Automix Channel Solo Enable
Command String:
< SET x CHAN_AUTOMIX_SOLO_EN ENABLE >
< SET x CHAN_AUTOMIX_SOLO_EN DISABLE >
where x is channel number: 0 is not
valid MXA910: channels 1-8; where
sts determines the requested state
of SOLO mode: ENABLE DISABLE
MXA310 Response:
< REP x CHAN_AUTOMIX_SOLO_EN ENABLE >
< REP x CHAN_AUTOMIX_SOLO_EN DISABLE >
where x is channel number: 0 is not
valid MXA910: channels 1-8; where
sts indicates channel x's SOLO
state: ENABLE DISABLE
Get Encryption Status (firmware > v2.0)
Command String:
< GET ENCRYPTION >
Get device level encryption status;
MXA310 Response:
< REP ENCRYPTION ON >
< REP ENCRYPTION OFF >
Send one of these commands to the
MXA310.