91
Chapter 2. Unpacking and First Operation
Fig. 21
Confirm the selection by pressing <ENTER>:
Fig. 22
At this point you can select the number of rinsing cycles (Fig. 19). Initial filling requires a minimum of two rinsing
cycles. You can stop the rinsing operation (Fig. 20) at any time by pressing <STOP> and then resume rinsing
with <START>.
Fig. 23
While the initial filling or rinsing programme is being run, please place a sufficiently dimensioned waste vessel
under the titration tip. The best is when the titration tip is mounted in the KF titration vessel.
To Next Page
Loading...
