Fig. 85
4.6.3 Titration parameters
The <Titration parameter> submenu is used to determine the actual parameters of the method. The parameters
were already introduced in chapter 4.6.2.1:
Fig. 86
Fig. 87
Generally applicable titration parameters
Depending on the titration mode (KF or dead stop titration) it is possible to enter a variety of parameters. The
following parameters are valid for the KF and dead stop titration modes:
• Initial waiting time
• Fixed delay
• Step size
• Pretitration
• Polarization voltage
• End of titration
To Next Page
Loading...
