Ch
eck your hydraulic installation for any
leaks or loose components.
Do not attempt to adjust the compass near a
steel bridge, a submarine cable, or a steel
ship.
Move your vessel to a location that is:
• Free from other water traffic.
• Far away from large magnetic objects.
9. RE-START SET-UP procedure at
Step 1 and follow until display shows
[FLUH]. Go to step 10.
10. Slowly turn the boat in as small a
circle as possible.
It must take at least one minute to complete
the turn. If the Compass adjustment is
satisfactory, the Autopilot will show [nort]. Go
to Step Thirteen.
If the Autopilot will not stop displaying [tUrN],
you may have such a strong magnetic field
aboard your vessel that the compass is not
able to sense any motion. If this occurs, try
moving the compass far away from it’s
present location and repeat the turn.
11. Use four #10 (5mm) screws to
mount your Fluxgate Compass.
These screws should be a non-magnetic
material such as high quality stainless steel
or brass.
If the Compass adjustment is not satisfactory the Autopilot will display
[MovE] (Move).
The Autopilot has been unable to adjust the Compass for the strong magnetic fields in that
location. You must select another location which is further from magnetic materials or power
cables. On small vessels the compass location often is a compromise between the most stable
position and the position which has the least magnetic interference.
Press the Pilot Key to continue the Set-up Routine.
To Next Page
