***** IMPORTANT *****
If the system you purchased includes a reversing motor pumpset, it is important that you apply
and install this unit correctly. To ensure that you get the most from your purchase, read this
installation and instruction manual carefully. By following the step-by-step procedure and using
only basic tools and materials, you will find the installation easy to do.
Caution
This Pump is not waterproof and is therefore not warranted against water damage.
This Pump is not warranted against damage caused by improper installation.
If you are installing this pump on a Capilano or Syten steering system, you probably have
a 3-line steering system. Read the 3-line steering installation instructions carefully.
Tools And Materials Required To Install Pump
1) Basic Tool Kit
2) Pipe Cutter
3) Funnel with Filter (a coffee filter will do)
4) 3/8" Electrical Drill
5) 2 gallon (9 L.) bucket (to catch excess
oil).
6) Rags or Paper Towels
7) Pipe Fittings (check with steering
gear manufacturer for type & size)
1
8) Tubing (check with steering gear
manufacturer for type and size)
1
9) Hydraulic Oil (check with steering
gear manufacturer for type)
1
10) Teflon based thread sealer (such as
LOCTITE™ P.S.T.)
11) Miscel
laneous Hard
ware
(for
mounting pump and securing lines)
1. Consult with your steering system manufacturer to get detailed
information about factory authorized materials. Failure to do so could void
your warranty.
To Next Page
Loading...
