Operation
The Second Station is identical in operation to the Main Station as described in “Piloting with the
SP-70 or SP-80 Autopilot”. Only one of the controls can operate the autopilot at any given time.
The unit that is non-active will have a continuously flashing LCD display and the active control will
have a steady display. To activate the non-active control, press and hold both the Red and Green
pushbuttons for 2 seconds. This control will now become active and go into the same mode as the
previously active control was operating in.
Turning the Autopilot ON From The Main Station or the Second Station
To turn the autopilot on from either the Main Station or the Second Station, press the pilot key on
one of these units. The Autopilot will turn on and the same station will become active. The display
is solid.
Turning the Autopilot off from the Main or Second Station
The autopilot can only be turned off from the active station. From the station that is in command,
press and hold the Off key for 2 seconds. The autopilot system will now turn off.
NON ACTIVE Station: The display keeps blinking or flashing.
To Next Page
Loading...
