SICK deTec4 Core Ex II 3GD - Mounting the Compact Flexfix Bracket

Further topics
•
"Sender and r
eceiver alignment", page 45
5.2.3 Mounting the Compact FlexFix bracket
Overview
W
ith a Compact FlexFix bracket, you can mount the sender and receiver closer to the
machine or profile frame.
2 Compact FlexFix brackets are used to mount the sender and receiver.
Exempt are devices with a protective field height of 150mm. One Compact FlexFix
bracket on each the sender and receiver is sufficient for mounting.
In the Compact FlexFix bracket, the sender and receiver can be rotated ±15° around
their longitudinal axis.
Important information
NOTICE
T
he housing of the safety light curtain can become scratched if the screw heads
protrude when the Compact FlexFix brackets are mounted on the back.
This can be avoided by taking the following measure:
b
Use countersunk screws without washer.
NOTICE
T
he AR60 optional laser alignment aid can be used from a protective field height of
250 mm.
Mounting method
T
able 5: Side and rear mounting of the Compact FlexFix bracket on a machine or profile frame
Mounting
me
thod
Description
On the side With the M5 screw through the Compact FlexFix bracket on the machine or
pr
ofile frame. A screw nut or threaded hole is required on the machine or
profile frame (1).
With the M5 screw through the Compact FlexFix bracket on the profile
fr
ame. 2 sliding nuts are required on the profile frame (2).
On the back With the M5 countersunk screw through the Compact FlexFix bracket on the
mac
hine or profile frame. A screw nut or threaded hole is required on the
machine or profile frame (3).
MOUNTING 5
8021796/1DCM/2022-10-27 | SICK O P E R A T I N G I N S T R U C T I O N S | deTec4 Core Ex II 3GD
39
Subject to change without notice