WARNING
Risk of injury and damage caused by potential equalization currents!
Improper grounding can lead to dangerous equipotential bonding currents, which may
in turn lead to dangerous voltages on metallic surfaces, such as the housing. Electrical
voltage can cause severe injury or death.
■
Work on electrical systems must only be performed by qualified electricians.
■
Follow the notes in the operating instructions.
■
Install the grounding for the product and the system in accordance with national
and regional regulations.
2.8 Warning signs on the device
Depending on the version of the device, it has a laser of Class 2 or Class 1 installed.
The device is labeled with a corresponding warning sign on the left side of the housing.
LASERGERÄT
MAX. OUTPUT ≤ 250mW
PULSELENGTH = 5ns
WAVELENGTH = 658nm
LASER
2
EN/IEC 60825-1:2014
Complies with 21 CFR
1040.10 and 1040.11
except for conformance
with IEC 60825-1 Ed. 3.,
as described in Laser Notice
No. 56, dated May 8, 2019.
1
2
3
5
4
Figure 1: Warning label on the device: laser class 2
1
Front of device
2
Position of the laser output aperture
3
CAUTION LASER RADIATION, Laser class 2 product, Do not look into the beam
4
Maximum output power, pulse length, wavelength
5
Complies with 21CFR 1040.10 and 1040.11 except for conformance with IEC
60825-1Ed. 3., as described in Laser Notice No. 56, dated May 8, 2019.
2 SAFETY INFORMATION
12
O P E R A T I N G I N S T R U C T I O N S | DT35S 8027663//2022-08-04 | SICK
Subject to change without notice
To Next Page
Loading...
Need help?
General
