SICK DT35S

•
Switching point: 15000mm
•
Hysteresis: 25mm
7.3.3.1 DtO Mode
The DtO mode can be configured via the switching function for Q1 and Q2. The digital
output can be parameterized for the Safety-related Zone near or Safety-related Zone far
behavior. The necessary settings can either be taught-in or set manually. These are
described in the following.
For a detailed functional description, see "Safety-related functions", page 16.
NOTE
The switching point can only be set in the valid measuring range from 50mm to
15,000mm.
When switching between the “Distance to object” (DtO mode) switching function and the
“Switching window” (Window mode) switching function, it is possible for the setting of the
previously selected switching behavior and/or the switching point setting to change.
Figure 19: Safety-related Zone near
Figure 20: Safety-related Zone far
COMMISSIONING AND CONFIGURATION
7
8027663//2022-08-04 | SICK O P E R A T I N G I N S T R U C T I O N S | DT35S
31
Subject to change without notice