SICK DT35S - Page 33

Figure 21: Double safety-related zone
Figure 22: Observation window
Setting Description
Behavior of digital
output
The “Switching behavior” setting can be used to manually select whether
the output should relate to the Double safety-related Zone (see figure 21,
page 33) or Observation window (see figure 22, page 33).
When the switching behavior is changed, the values set for switching
point1 and switching point2 are automatically swapped by the device.
Switching point1
•
With the “Switching point1” setting, the first of the two switching
points of the switching window can be set manually in millimeters.
•
The first of the two switching points can be taught in for the Switching
window (Window mode) switching mode using the “Switching point1”
teach method.
For Double safety-related zone (see figure 21, page 33), “Switching point1”
must be taught in first, for Observation window (see figure 22, page 33),
“Switching point2” must be taught in first to avoid switching the behavior
twice during teach-in.
COMMISSIONING AND CONFIGURATION 7
8027663//2022-08-04 | SICK O P E R A T I N G I N S T R U C T I O N S | DT35S
33
Subject to change without notice