Figure 7: Each of the 16 horizontal point lines is created by one scan layer of the device. In the
example, four people have been detected by the device.
Due to their conical shape, all scan layers except for the one with an elevation angle
of 0° are bent slightly upwards or downwards when they hit a flat object depending
on where the cone opens out. The larger the elevation angle value, the stronger the
curvature.
Figure 8: Cone-shaped scan layer as the cause for a bent scan line
3
PRODUCT DESCRIPTION
16
O P E R A T I N G I N S T R U C T I O N S | multiScan136 8027119/0000/2022-11 | SICK
Subject to change without notice
To Next Page
Loading...
