8 Maintenance
8.1 Maintenance plan
During operation, the device works maintenance-free.
NOTE
No maintenance is required to ensure compliance with the laser class.
Depending on the assignment location, the following preventive maintenance tasks
may be required for the device at regular intervals:
Table 12: Maintenance plan
Maintenance work Interval To be carried out
by
Check device and connecting cables
for damage at regular intervals.
Depends on ambient conditions and
climate.
Specialist
Clean housing. Depends on ambient conditions and
climate.
Specialist
Clean housing and optics cover. Depends on ambient conditions and
climate.
Specialist
Check the screw connections and
plug connectors.
Depends on the place of use, ambi‐
ent conditions or operating require‐
ments. Recommended: At least every
6 months.
Specialist
Check the mounting accessories and
vibration dampers used.
Depends on the place of use, ambi‐
ent conditions or operating require‐
ments. Recommended: At least every
6 months.
Specialist
8.2 Cleaning
NOTICE
Equipment damage due to improper cleaning.
Improper cleaning may result in equipment damage.
■
Only use recommended cleaning agents and tools.
■
Never use sharp objects for cleaning.
b
Clean the optics cover at regular intervals and in the event of contamination with
a lint-free lens cloth (part number 4003353) and plastic cleaning agent (part
number 5600006). Rinse off coarse dirt first with water. The cleaning interval
essentially depends on the ambient conditions.
NOTICE
If the optics cover is scratched or damaged (cracked, broken), it must be replaced.
Contact SICK Support to arrange this.
■
If the optics cover is cracked or broken, take the device out of operation immedi‐
ately for safety reasons and have it repaired by SICK.
8 MAINTENANCE
50
O P E R A T I N G I N S T R U C T I O N S | multiScan136 8027119/0000/2022-11 | SICK
Subject to change without notice
To Next Page
Loading...
