Need help?Do you have a question about the SICK PGT-12-Pro and is the answer not in the manual?
General| Brand | SICK |
|---|---|
| Model | PGT-12-Pro |
| Category | Media Converter |
| Language | English |
Defines the purpose of these operating instructions for technical personnel.
Explains symbols like CAUTION and notes on disposal.
Lists other relevant operating instructions for encoders and sensors.
States that the PGT-12-Pro is maintenance-free and not designed for repair.
Provides guidance on disposing of unserviceable devices and batteries.
Details how to insert or replace batteries, including warnings and disposal information.
Instructions for inserting and removing the SD card from the PGT-12-Pro.
Explains how to connect the PGT-12-Pro to other devices using adapter cables.
Describes how to turn the PGT-12-Pro on and off.
Guides users on how to change the menu language, noting setup menu remains English.
Details the process of programming individual devices with parameter values.
Explains how to copy parameter settings from one device to another.
Describes how to program multiple device types using the PGT-12-Pro's memory.
Instructions for saving parameter settings from the PGT-12-Pro to an SD card.
Guides on loading parameter settings from an SD card to a device using the PGT-12-Pro.
Explains how to activate password protection for the PGT-12-Pro's Setup menu.
Details the process of updating the PGT-12-Pro firmware via an SD card.
Describes how to set or scan the baud rate for CANopen devices.
Explains how to configure the transmission mode for TPDOs on CANopen devices.
Details how to map Transmit PDOs for AHS/AHM encoders.
Illustrates how to connect devices via a spring terminal block.
Shows how to connect the PGT-12-Pro to devices using specific adapter cables.
Information on obtaining conformity declarations, certificates, and instructions from www.sick.com.
To Next Page
