Siebert S102 Series - Attributes for Flashing and Blinking (Property Numbers 7 and 9); Format (Property Numbers 10 and 11)

BAL S102 PFN RT 1.00 18/24
Attributes for flashing and blinking (property numbers 7 and 9)
With these initialization values, the flashing modes for the standard display and the 'out of range'
display can be defined.
See chapter .Flashing modes.
Pos: 46 /Siebert/B edienungsanlei tungen/Seri e S102/SX102/Einst ellung der Darst ellungsart bei der Initialisi erung (nur nu merische Betriebsart)/ Format/S10 2 Format (prop erty numbers 10 und 11) PFN RT @ 4\mo d_148518435 7493_48.docx @ 2 7053 @ 2 @ 1
F
Format (property numbers 10 and 11)
These two initialization parameters define the alignment of the displayed values and the number of
leading zeros.
Meaning
Property number
Data type
Default values
Minimum number of digits
10
UINT8
1
Minimum width
11
UINT8
30
The minimum number of digits displayed is defined as 'Minimum number of digits'. If the value to be
displayed has less digits than 'Minimum number of digits', the display is filled with zeros on the left
side.
Example: For a six-digit display the 'Minimum number of digits' is set to 6. If the number '1234' is sent
to the display, the display shows '001234'.
'Minimum Width' defines the minimum number of digits used for display. If the number representation
contains less characters (including the sign), the space is filled with blanks on the left side.
Example: To display a number on the left-hand side, set the parameter 'Minimum Width' to '1'.
Pos: 47 /Siebert/S eitenumbruc h @ 0\mod_1314 194553878_0. docx @ 150 @ @ 1