Siegenia KFV GENIUS 2.2 PANIC - Safety notes and warning systems

01.20206/45 H39.ELEKS014EN-00

GENIUS 2.2 PANIC, Electromechanical mul-point lock
• do not interfere with and/or make any modicaons
to the GENIUS 2.2 PANIC.
• Do not aempt to repair the GENIUS 2.2 PANIC.
If it is damaged, the GENIUS 2.2 PANIC must be
replaced. The GENIUS 2.2 PANIC must be replaced
once it reaches the service life indicated below:
– primary sash ("acve sash") for 1- and 2-sash
doors: 200,000 acvaons of the operang
handle
– GENIUS 2.2 drive:
100,000 locking and unlocking acons (motor-
ised)
• Foreign objects and/or materials which impede or
prevent proper use must not be placed within the
opening range, the locking system or the striker
plates.
• Locking elements must not be misused to hold the
door open.
• All funcons of the GENIUS 2.2 PANIC are only com-
pletely available aer the described commissioning
process.
 
• The transit support provided must remain in the
main lock during the transport of a pre-assembled
door without cylinder lock.
• In the installed and non-installed status of the mul-
-point lock, ensure that the locking elements are in
the release posion.
• Mul-point locks are sensive components and
must therefore be handled with care. For example,
they must not be thrown, hit hard or bent.
• Do not carry the door by the lever handle or hard-
ware when transporng it.
 
You will need the following protecve equipment when
assembling a mul-point lock:
• safety shoes
• protecve gloves
• protecve goggles
 
• All work on the 230 V AC mains power supply
must be carried out in compliance with the current
German VDE regulaons (e. g., VDE 0100) and any
relevant country-specic requirements.
• All-pole safety isolaon should be used when rout-
ing the power supply network connecon cable
on-site.
• Wiring the unit incorrectly can irreparably damage
its electronic components.
• If energy-carrying cables are routed in parallel to
data cables (ISDN, DSL, etc.), this could lead to inter-
ference e.g. in the speed of the data transmission.
Only use the shielded original KFV cable.
 
The warning notes in these instrucons
• when observed, provide protecon against potenal
personal injury and material damage,
• classify the level of danger by the signal word,
• designate the danger of personal injury via the
hazard sign,
• dene the type and source of danger,
• show measures to prevent hazards and prohibit
specic behaviour.
The warning notes are set up according to the following
principle:
SIGNAL WORD

explanaon of the type and source of danger
• measures for the prevenon of the danger
the hazard sign designates warning noces that warn
of personal injury.
The type and source of the hazard denes the cause of
the hazard. The potenal consequences of non-obser-
vaon of warning noces are e.g. danger to life due to
electric shock.
Under measures, acons are listed that must be carried
out for the prevenon of hazards or which are prohibit-
ed for the prevenon of a hazard.
 
DANGER
The signal word "Danger" designates an immediately
threatening danger. If this hazard is not prevented, it
leads to death or severe injuries.
WARNING
The signal word "Warning" designates a potenal
hazard. If this hazard is not prevented, it could lead to
death or severe injuries.
CAUTION