Commissioning
7.1 Measures prior to commissioning
Synchronous Motors 1FK7
38 Operating Instructions, 03/2011, 610.40700.40c
● All fixing screws, connecting elements, and electrical connections are tight and have
been attached properly.
● The transmission elements have the proper setting conditions according to type, for
example:
– Couplings are aligned and balanced.
– The belt tension is properly adjusted if a belt drive is used.
– Gear tooth flank play and gear tooth tip play as well as radial play are properly
adjusted if a gear drive is used.
Electrical connection
Make sure that:
● The grounding and equipotential bonding connections have been established correctly.
● The brake is operating perfectly.
● The specified speed limit n
max
is not exceeded when operated from a converter.
Monitoring equipment
Make sure that:
● Appropriately configured control and speed monitoring functions are being used to ensure
that the motor cannot exceed the permissible speeds specified on the rating plate.
● Any supplementary motor monitoring devices and equipment have been correctly
connected and are fully functional.
Brake (optional)
Make sure that:
● Applying the operating voltage causes the brake to open.
● The brake functions (opens, closes) correctly.
EUROSERVO SERVO MOTOR TAMİR MERKEZİ
WWW.EUROSERVO.COM.TR
To Next Page
Loading...
