EasyManuals Logo

Siemens 1FK7 Series User Manual

Siemens 1FK7 Series
58 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #44 background imageLoading...
Page #44 background image
Operation
8.2 Faults
Synchronous Motors 1FK7
42 Operating Instructions, 03/2011, 610.40700.40c
8.2 Faults
Note
Damage to the machine caused by faults
Correct the cause of the fault as specified in the remedial measures section. Repair any
damage to the machine/motor.
Note
When operating the motor with a converter, refer also to the operating instructions of the
frequency converter if electrical faults occur.
If there are deviations from normal operation or if faults occur, initially proceed according to
the following list. In this regard, observe the relevant chapters in the documentation
associated with the components of the complete drive system.
Even in test operation, never disable protective functions or devices.
Table 8- 1 Possible faults
Fault Cause of fault (see key table)
Motor does not start A B
Motor starts slowly A C F
Humming sound when starting C F
Humming sound in operation A C F
High temperature rise under no-load
operation
D GHI
High temperature rise under load A C G H I
High temperature rise of individual
winding sections
F
Uneven running J K
Grinding sound, running noise L
Radial vibrations M N O P R
Axial vibrations O Q R
EUROSERVO SERVO MOTOR TAMİR MERKEZİ
WWW.EUROSERVO.COM.TR

Other manuals for Siemens 1FK7 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens 1FK7 Series and is the answer not in the manual?

Siemens 1FK7 Series Specifications

General IconGeneral
Product typeSynchronous motor
EncoderIncremental encoder, absolute encoder
Cooling methodNatural cooling, forced-air cooling
Degree of protectionIP64, IP65
Speed rangeUp to 9000 rpm
Feedback systemEncoder or resolver

Related product manuals