Siemens 1FK7 Series User Manual

Maintenance
9.2 Repair
Synchronous Motors 1FK7
50 Operating Instructions, 03/2011, 610.40700.40c
Note
Coupling element
When replacing the encoder, the coupling element must also be replaced.
Motors with DRIVE-CLiQ
NOTICE
Motor data (electronic rating plate)
You must ensure that the new encoder contains the correct motor data. If it does not, the
motor may move in an uncontrolled fashion, leading to considerable material damage.
You can purchase a preprogrammed encoder module from the Siemens Service Center by
quoting the relevant order number and serial number. If your encoder module is not
preprogrammed, it must be programmed with the correct motor data prior to use.
EUROSERVO SERVO MOTOR TAMİR MERKEZİ
WWW.EUROSERVO.COM.TR

Siemens 1FK7 Series Specifications

General

Product type	Synchronous motor
Encoder	Incremental encoder, absolute encoder
Cooling method	Natural cooling, forced-air cooling
Degree of protection	IP64, IP65
Speed range	Up to 9000 rpm
Feedback system	Encoder or resolver