Siemens 7SR224 - Page 192

7SR224 Argus Data Comms
Information Object Addresses (IOA)
The following table lists information object address (IOA) definitions together with a description of the message
and default function type of that message. Definitions with shaded area are not available on all relay models.
The Default type is given below but all items are user configurable.
IOA Description Default Type
1 Data Lost M_SP_TB_1
4 Remote Mode
M_SP_TB_1
C_SC_NA_1
5 Service Mode
M_SP_TB_1
C_SC_NA_1
6 Local Mode
M_SP_TB_1
C_SC_NA_1
7 Local & Remote Mode
M_SP_TB_1
C_SC_NA_1
12 Control Received
M_SP_TB_1
13
Command Received
M_SP_TB_1
14
Cold Start
M_SP_TB_1
15
Warm Start
M_SP_TB_1
16
Re-start
M_SP_TB_1
17
Trigger Storage
M_SP_TB_1
18
Clear Waveform Records
M_SP_TB_1
19
Clear Fault Records
M_SP_TB_1
20
Clear Event Records
M_SP_TB_1
21 Reset Demand metering
M_SP_TB_1
C_SC_NA_1
22
27 Sag SARFI
M_SP_TB_1
23
59Swell SARFI
M_SP_TB_1
24
Reset SagSwell Count
M_SP_TB_1
25
Battery Test Pass
M_SP_TB_1
26
Battery Test Fail
M_SP_TB_1
27
Battery Ohms High
M_SP_TB_1
28
Battery Volts Low
M_SP_TB_1
29
Battery Volts High
M_SP_TB_1
30
Battery Healthy
M_SP_TB_1
31
Battery Recovery Fail
M_SP_TB_1
32 Battery Test
M_SP_TB_1
C_SC_NA_1
33
Capacitor Ready
M_SP_TB_1
34
Capacitor Test Pass
M_SP_TB_1
35
Capacitor Test Fail
M_SP_TB_1
36
Capacitor Recovery Fail
M_SP_TB_1
37 Capacitor Test
M_SP_TB_1
C_SC_NA_1
38 General Alarm 1 M_SP_TB_1
39 General Alarm 2 M_SP_TB_1
40 General Alarm 3 M_SP_TB_1
41 General Alarm 4 M_SP_TB_1
©2010 Siemens Protection Devices Limited Chapter 4 Page 58 of 76