Siemens 7SR224 - Section 2: Setting the Relay Using Reydisp Evolution; Physical Connection; Front USB Connection

7SR224 Argus Settings, Configuration & Instruments
©2010 Siemens Protection Devices Limited Chapter 2 Page 9 of 13
Section 2: Setting the Relay Using Reydisp Evolution
To set the relay using the communication port the user will need the following:-
PC with Reydisp Evolution Installed. (This can be download from our website www.siemens.com/energy
and
found under the submenu ‘Software’)This software requires windows 2000-service pack 4 or above, or windows
XP with service pack 2 or above.
2.1 Physical Connection
The relay can be connected to Reydisp via any of the communication ports on the relay. Suitable communication
Interface cable and converters are required depending which port is being used.
2.1.1 Front USB connection
To connect your pc locally via the front USB port.
Figure 2.1.1-1 USB connection to PC
Local
Enginee
r
A
ccess
USB Data Cable
USB Type A
USB Type B Male
USB Type B
Female socket on
USB Type A
Relay
Socket on PC