7SR224 Argus Settings, Configuration & Instruments
©2010 Siemens Protection Devices Limited Chapter 2 Page 13 of 13
2.1.6 Connecting to the Relay via Reydisp
When Reydisp software is running all available communication ports of the PC will automatically be detected.
On the start page tool bar open up the sub-menu File > Connect.
The ‘Communication Manager’ window will display all available communication ports. With the preferred port
highlighted, select the ‘Properties’ option and ensure the baud rate and parity match that selected in the relay
Data Comms settings. Select ‘Connect’ to initiate the relay-PC connection.
Figure 2.1.5-1 PC Comm Port Selection
Via the Relay > Set Address > Address set the relay address (1-254) or alternatively search for connected
devices using the Relay > Set Address > Device Map. The relay can now be configured using the Reydisp
software. Please refer to the Reydisp Evolution Manual for further guidance.
To Next Page
Loading...
