Siemens ET 200S - Page 216

Interface Modules
8-2
Distributed I/O System ET 200S
EWA 4NEB 780 6024-02 07
Table 8-1 Parameters for the IM151-1 BASIC Interface Module
IM151-1 BASIC ApplicabilityDefaultValue Range
Reference junction
slot
None/2 to 12 None ET 200S
Reference junction
input
RTD on channel 0/
RTD on channel 1
0 ET 200S
Parameters for the IM151-1 STANDARD and IM151-1 FO STANDARD Interface
Modules
Table 8-2 Parameters for the IM151-1 STANDARD and IM151-1 FO STANDARD Interface
Modules
IM151-1
STANDARD/
IM151-1 FO
STANDARD
Value Range Default Applicability
Startup at Preset <>
Actual configuration
Disable/enable Disable ET 200S
Replace modules
during operation
Disable/enable Disable ET 200S
Analog-value format SIMATIC S7/
SIMATIC S5
S7 ET 200S
Interference
frequency
suppression
50 Hz/60 Hz 50 Hz ET 200S
Reference junction
slot 1 to 8
None/2 to 63 None ET 200S
Reference junction
input 1 to 8
RTD on channel 0/
RTD on channel 1
0 ET 200S
Parameters for the IM151-1 HIGH FEATURE Interface Module
Table 8-3 Parameters for the IM151-1 HIGH FEATURE Interface Module (Parameter
Assignment Tab)
IM151-1 HIGH
FEATURE
Value Range Default Applicability
DPV1 operation Disable/enable Enable
1
ET 200S
Operation at Preset
<> Actual
configuration
Disable/enable Enable ET 200S
Diagnostic interrupt
2
Disable/enable Disable ET 200S
Hardware interrupt
2
Disable/enable Disable ET 200S