Siemens ET 200S - Page 267

10-1
Distributed I/O System ET 200S
EWA 4NEB 780 6024-02 07
Power Modules
Chapter Overview
Section Description Page
10.1 Parameters for Power Modules 10-1
10.2 PM-E 24 VDC Power Module (6ES7 138-4CA00-0AA0) 10-2
10.3 PM-E 24–48 VDC / 24–230 VAC Power Module
(6ES7 138-4CB10-0AB0)
10-6
10.1 Parameters for Power Modules
Parameters
The following table describes the parameters of the 24 VDC and 24 VDC /
120/230 VAC power modules.
Table 10-1 Parameters for Power Modules
PM-E 24 VDC
Power Module
PM-E 24–48
VDC/
120–230 VAC
Power Module
Value Range Default Applicability
Diagnostics:
No load voltage
Diagnostics:
No load voltage
Disable/enable Disable Power module
––– Diagnostics:
Fuse blown
Disable/enable Disable Power module
––– Voltage type DC/AC DC Power module
10