Siemens ET 200S - Page 417

Analog Electronic Modules
12-61
Distributed I/O System ET 200S
EWA 4NEB 780 6024-02 07
Table 12-74Parameters for Analog Input Modules RTD, TC
2AI RTD
Standard
Applica-
bility
DefaultValue Range2AI TC High
Feature
2AI TC
Standard
––– Type/range
of measure-
ment
–––  Deactivated
 Voltage  80 mV
 TC-EL type T (Cu-CuNi)
 TC-EL type K (NiCr-Ni)
 TC-EL type B (PtRh-PtRh)
 TC-EL type N (NiCrSi-NiSi)
 TC-EL type E (NiCr-CuNi)
 TC-EL type R (PtRh-Pt)
 TC-EL type S (PtRh-Pt)
 TC-EL type J (Fe-Cu-Ni)
 TC-EL type L (Fe-Cu-Ni)
TC-EL
type K
(NiCr-Ni)
Channel
Type/range of
measurement
 Deactivated
 Voltage  80 mV
 TC-EL type T (Cu-CuNi)
 TC-EL type K (NiCr-Ni)
 TC-EL type B (PtRh-PtRh)
 TC-EL type C (WRe-WRe)
 TC-EL type N (NiCrSi-NiSi)
 TC-EL type E (NiCr-CuNi)
 TC-EL type R (PtRh-Pt)
 TC-EL type S (PtRh-Pt)
 TC-EL type J (Fe-Cu-Ni)
 TC-EL type L (Fe-Cu-Ni)
TC-EL
type K
(NiCr-Ni)
Channel
1
Only with thermocouples. A parameter assignment error occurs when the wire break diagnosis is enabled
in the voltage measuring range. The module does not start up.
2
The wire break is only detected with constant-current lines.