4 IQ-SENSE
13-11
Distributed I/O System ET 200S
EWA 4NEB 780 6024-02 07
Table 13-3 Enhanced Feedback Interface
Address Designation on
“IQ-SENSE Opto” FB
Assignment
Byte 1 Bit 0: Circuit state sensor on channel 1 Q_CH1Byte 1 Bit 0: Circuit state sensor on channel 1 Q_CH1
1: Object detected1: Object detected
0: Object not detected0: Object not detected
Bit 1 to bit 7:
Acquired sensitivity/distance values
on channel 1 by teach-in *
TEACH_VAL_OUT
Byte 2 Bit 0: Circuit state sensor on channel 2 Q_CH2Byte 2 Bit 0: Circuit state sensor on channel 2 Q_CH2
1: Object detected1: Object detected
0: Object not detected0: Object not detected
Bit 1 to bit 7:
Acquired sensitivity/distance values
on channel 2 by teach-in *
TEACH_VAL_OUT
Byte 3 Bit 0: Circuit state sensor on channel 3 Q_CH3Byte 3 Bit 0: Circuit state sensor on channel 3 Q_CH3
1: Object detected1: Object detected
0: Object not detected0: Object not detected
Bit 1 to bit 7:
Acquired sensitivity/distance values
on channel 3 by teach-in *
TEACH_VAL_OUT
* The current sensitivity/distance value is entered:
- After teach-in is completed on the sensor
- After teach-in is completed via the “IQ-SENSE Opto” FB
To Next Page
Loading...
