Siemens ET 200S - Page 506

4 IQ-SENSE
13-12
Distributed I/O System ET 200S
EWA 4NEB 780 6024-02 07
Control Interface (PIQ)
Table 13-4 Enhanced Control Interface
Address
Assignment Designation on
“IQ-SENSE Opto” FB
Byte 0 Specify sensitivity/distance value on
channel 0
 Bit 0:
1: Transfer sensitivity/distance value to the
sensor on channel 0
(using rising edge)
0: Deactivated
WR_TEACH_VAL
 Bit 1 to bit 7:
Sensitivity/distance value
on channel 0: 1 to 126 (depending on the
sensor)
TEACH_VAL_IN
Teach-in on the sensor on channel 0
 Bit 0:
1: Start teach-in on the sensor on channel 0
(at the rising edge)
0: Deactivated
 Bit 1 to bit 7: 0
START_TEACH
Byte 1 Specify sensitivity/distance value on
channel 1
 Bit 0:Bit 0:
1: Transfer sensitivity/distance value to the
WR_TEACH_VAL
sensor on channel 1
(using rising edge)
0: Deactivated


Bit 1 to bit 7:
Sensitivity/distance value
TEACH_VAL_IN
on channel 1: 1 to 126 (depending on the
sensor)
Teach-in on the sensor on channel 1
 Bit 0:
1: Start teach-in on the sensor on channel 1
(at the rising edge)
0: Deactivated
 Bit 1 to bit 7: 0
START_TEACH