64 / 84
BA 9142 en 02/2015
8. Operation
Observe the instructions in section 3. "Safety instructions", in section 9. "Faults, causes and remedy" and
in section 10. "Maintenance and repair"!
8.1 General
To achieve a satisfactory operation of the equipment without failures, be certain to observe the operating
values specified in section 1. "Technical Data", as well as the information given in the operating
instructions of the oil-supply system.
During operation, the gear unit must be monitored for the following:
□ Oil temperature
The gear unit is designed for an oil distribution
temperature
in continuous operation of:
50 °C (122 °F)
If the oil-supply temperature reaches critical values
(see lubrication plan and equipment list), the gear unit
must be shut down immediately and Siemens
consulted.
□ Oil pressure of the oil-supply system or
gear unit lubricating system
□ Changes in gear noise
□ Possible oil leakage at the housing and
shaft seals
□ Bearing vibrations with
present measuring device
□ Storage temperatures with existing
temperature monitoring
To Next Page
Loading...
Need help?
General
