5 / 84
BA 9142 en 02/2015
Contents
1. Technical data 8.....................................................
1.1 General technical data 8...............................................................
1.2 Measuring-surface sound pressure level 8...............................................
1.3 List of equipment 8....................................................................
2. General notes 9.....................................................
2.1 Introduction 9........................................................................
2.2 Copyright 9..........................................................................
3. Safety instructions 10.................................................
3.1 Obligations of the user 10...............................................................
3.2 Special dangers and personal protective equipment 12......................................
3.3 The five safety rules 13.................................................................
3.4 Environmental protection 13.............................................................
4. Transport and storage 14.............................................
4.1 Content and check of the scope of delivery 14.............................................
4.2 Transport 14..........................................................................
4.3 Storing the gear unit 17.................................................................
4.4 Standard coating and corrosion prevention 18.............................................
4.4.1 Exterior preservation of metallic bright exterior surfaces 19..................................
4.4.1.1 Maximum durability period of the exterior preservation 19....................................
4.4.1.2 Prolongation of the preservation of metallic bright exterior surfaces of the gear unit 19...........
4.4.2 Preservation of the interior of the gear unit 19..............................................
4.4.2.1 Maximum durability period of the interior preservation of the gear unit 19.......................
4.4.2.2 Combined storage/packaging 21.........................................................
4.4.3 Renewal of the interior preservation of the gear unit for longer periods of storage of the
gear unit that has not been taken into operation yet 25......................................
4.4.3.1 Renewal of the gear unit interior preservation with "Castrol Corrosion Inhibitor N 213" 25.........
4.4.3.2 Renewal of the gear unit interior preservation through complete filling with preservative
or operating oil 27......................................................................
4.4.3.3 Renewal of the interior preservation of the gear unit using the oil-supply system 29..............
5. Technical description 31..............................................
5.1 General description 31.................................................................
5.2 Delivery condition of the gear unit 31.....................................................
5.3 Lubrication 32.........................................................................
5.3.1 Hydrodynamic lubrication of the axial tilting pad thrust bearings 32............................
5.3.2 Hydrodynamic lubrication of the axial tilting pad thrust bearings in gear units
with hydrostatic start-up assistance 32....................................................
5.3.3 Hydrodynamic lubrication of the axial tilting pad thrust bearings with radial piston pump 32.......
5.3.4 Labyrinth seals 33.....................................................................
5.4 Drive coupling 33......................................................................
5.5 Heating 34............................................................................
5.6 Indication of oil level 34.................................................................
5.7 Oil temperature monitoring 35...........................................................
To Next Page
Loading...
Need help?
General
