83 / 84
BA 9142 en 02/2015
12. Declarations
12.1 Declaration of incorporation
Declaration of incorporation
in accordance with Directive 2006/42/EC, Annex II 1 B
The manufacturer, Siemens AG, 46395 Bocholt, Germany, declares with regard to the partly completed
machinery
Vertical mill gear unit
KMP, KMPS, KMPP
for driving vertical mills:
– The special technical documents described in Annex VII B have been prepared.
– The following basic health and safety requirements set out in Directive 2006/42/EC, Annex I, are applied
and are satisfied:
1.1, 1.1.2, 1.1.3, 1.1.5; 1.2.4.4, 1.2.6; 1.3.1 ‐ 1.3.4, 1.3.6 ‐ 1.3.8.1; 1.4.1, 1.4.2.1;
1.5.1, 1.5.2, 1.5.4 1.5.11, 1.5.13, 1.6.1, 1.6.2; 1.7.1, 1.7.1.1, 1.7.2, 1.7.4 ‐ 1.7.4.3
– The partly completed machinery must not be put into service until it has been established that the
machinery into which the partly completed machinery is to be incorporated has been declared to be in
conformity with the provisions of Directive2006/42/EC, as appropriate.
– The manufacturer undertakes, in response to a reasoned request by the national authorities, to transmit in
electronic form relevant information about the partly completed machinery.
– The person authorised to compile the relevant technical documentation is:
Mark Zundel (PD MD AP EMEA VOE OE)
Voerde, 2015‐02‐30
Mark Zundel
(PD MD AP EMEA VOE OE)
Voerde, 2015‐02‐30
Dr. Bernhard Hoffmann
(PD MD AP)
To Next Page
Loading...
Need help?
General
