Siemens hicom 150 e - Page 95

Installing the Hardware
95
Pin Assignments
Two 8-pin and two 6-pin modular phone jacks are located on the
back of the U
P0/E
PCI card:
z
Jack SYS (8-pin): Connection to Hicom 150 E Office (the two
center pins 4 and 5 are the U
P0/E
(Digital station port) lines to
the Hicom system)
z
Jack HA (8-pin): Port for handset cradle and handset
z
Jack OUT (6-pin): Port for external recording equipment
z
Jack IN (6-pin): Not used
In addition, one yellow LED and one red LED are on the back of the
card to indicate the following U
P0/E
PCI card statuses:
z
Red LED illuminated: Card error
z
Yellow LED flashing: Card in operation
z
Yellow LED illuminated: Data being transferred between card
and Hicom system