Display Configuration Instructions
Mode Selection: The meter display can be toggled between the Auto Cycle mode
(default) and the Manual Cycle and Hold mode by pushing/holding the meter display
button for > 5 seconds, This mode change is saved to non-volatile memory in case of
power loss.
Auto Cycle: The display will auto cycle between flowchart screens every 2 seconds.
Pushing the meter display button < 5 seconds will temporarily hold the current screen
until either the display button is pushed again or until a 20-second default timeout
occurs, returning it to auto cycle.
Manual Cycle and Hold: The display will manually advance the flowchart screens by
pushing the meter display button multiple times. The display screen will remain in the
last displayed mode, updating values continuously.
To Next Page
Loading...
