Siemens MOBILETT Plus HP Installation And Setting Instructions

MOBILETT Plus HP SPR8-220.033.03 Page 2 of 12 Siemens-Elema AB
Rev. 02 10.02 SPS-UD Solna, Sweden
2 - 2 Installation and setting
•
Mount the main switch label 65 90 827 next to the mains switch as shown in Fig. 3. The
main switch label comes in different languages.
Then mount the other warning label 65 84 606 as shown in Fig. 3.
• Check the unit for cracks, fractures or other damages.
• Make sure that neither the single tank nor the collimator has any mechanical defects
which would impair the radiation protection.
The following labels come in different languages. Pick the proper
ones and paste them according to Fig. 3.
NOTE
MOB00600
This product complies with DHHS regulations
21 CFR Subchapter J. applicable at date of
manufacture.
Manufactured:
Siemens Aktiengesellschaft
Wittelsbacherplatz 2. D - 80333 Mnchen
Germany
X-Ray Equipment.
Classified by
Underwriters Laboratories Inc.
with Respect to Electrical Fire, Shock,
and Mechanical Hazards Only.
245 B
CERTIFIED TO THE REQUIREMENTS
OF THE CANADIAN ELECTRICAL
CODE. CSA HAS NOT INVESTIGATED
OTHER PHYSIOLOGICAL EFFECTS.
CERTIFI SELON LES EXICENCES DU
CODE CANADIEN DE L’LECTRICIT
L’ACNOR N’A PAS TUDI LES AUTRES
EFFETS PHYSIOLOGIQUES POSSIBLES.
LR56549C
R
R
DANGER! Explosion hazard.
Do not use in the presence of
flammable anaesthetics. 
Read technical documents before
removing the covers.
Always turn the main switch to C
when not using the MOBILETT.
Main switch labe
l
Fig. 3
Warning label

Siemens MOBILETT Plus HP Specifications

General

Brand	Siemens
Model	MOBILETT Plus HP
Category	Medical Equipment
Language	English