Pop-up command menu for a single NK82xx branch
⚫ Send commands to a specific NK82xx by clicking the Commands icon and then
selecting the command in the pop-up menu. The command list includes:
– Build Identification: Start a CEI 97-5 identification procedure.
– Get Version: Get and display the NK82xx version.
– Out scan: Set the NK82xx unit out of scan. After that, the In Scan
command will be available.
– Reset: Launch a reset of the NK82xx unit
– Synchronize date/time: Send a date and time message to the NK82xx unit.
– Update branch: Refresh the status line of the NK82xx unit.
– Vitality: Get and show the status of the NK82xx unit in a pop-up window.
Note: The command menu options are reduced if the selected branch is not
connected or is set as out of scan.
⚫ Send commands to all NK82xx units by clicking the NK8000 icon on the top left
and selecting the command in the pop-up menu. The command list includes:
– Get the NS8210 Log Files: Upload and show the NS8210 driver logs.
– Get all versions: Get and display the version of all NK82xx units.
– Synchronize date/time: Send a date and time message to all NK82xx units.
Pop-up command menu for all NK82xx branches
To Next Page
Loading...
