Enhanced phone functions
107
Step by Step
Activating/deactivating Hold and hang-up
This function works in the following call scenarios:
• You have placed a call on hold and hang up.
• You accepted a second call, and you or the second
participant hang up.
You can use "hold and hang up" to determine whether
you will be prompted immediately of after a defined
time to retrieve the held call.
z
You can also configure this setting via the WEB
Surface  page 271.
v Press the key shown until "Settings" is active.
Confirm the option shown.
if nec. j Enter and confirm the user password.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
In the context menu select and confirm the option
shown to activate the function or
Select and confirm the option shown to deactivate the
function again. The function is always deactivated by
default.
Select and confirm the option shown.
This function cannot be used on multi-line
phones.
User
Configuration
Connected calls
Hold and hang-up
Yes
No
Save & exit
To Next Page
Loading...
Need help?
General