Siemens PCS 7 - Topology Editor (PROFINET)

Overview
Topic Detailed information Called via Additional information
General CP
diagnostics and
statistics
functions
Operating mode
Connected stations
Station-related statistics
functions
Station overview
General" tab ● Online help NCM
Diagnostics, Topic
"General diagnostic
functions"
● Manual SIMATIC
NET; NCM S7 for
PROFIBUS
Mode-specific
diagnostics
Dynamic information about
the operating mode of the
communication functions of
CPs connected online
FMS connections DP master diagnostics
Communication status of
slaves and call of data for DP
slave diagnostics
DP slave diagnostics (non-
passive slaves)
PROFIBUS
connections
DP master
DP slave
FDL connection
FMS connection
PROFIBUS
connections
Faults and inconsistencies in
FMS connections of the CP
PROFINET
connections
7.18.3.6 Topology Editor (PROFINET)
Calling
Select the PROFINET IO system (e.g. in HW Config) and call the following menu command:
Edit > PROFINET IO > Topology.
Overview
Topic Detailed information Called via Additional information
Devices and
interconnections
Checking the configured
devices and interconnections
● "Table view" tab >
"Online" button
● "Graphic view" tab
> "Online" button
Online help for Topology
Editor > "Table view" tab
Devices and
interconnections
Offline/online comparison ● "Offline/online
comparison" tab >
"Start" button
Online help for Topology
Editor > "Offline/online
comparison" tab
Diagnostics in PCS 7
7.18 Diagnostic tools
Service support and diagnostics (V8.0)
100 Service Manual, 03/2012, A5E02779775-02