Siemens PCS 7 - How to Determine the Source of a Message

originate, all messages are handled in the same way regarding how they are displayed and
archived on the PCS 7 OS.
$6&3
&38
26&3
0HVVDJH
$ODUP$UFKLYLQJ
2ULJLQRID3URFHVV0HVVDJH
3URFHVVVLJQDOIDXOW\
9LVLDOL]DWLRQ
3ODQW%XV
$$$
Figure 5-1 The letter "A" in the picture symbolizes an alarm message in PCS 7.
Additional information
You can find information on configuring messages in the following documentation:
● Configuration manual
Process Control System PCS 7; Engineering System
● Configuration manual Process Control System PCS 7; Operator Station
For information on configuring messages with enhanced time stamp accuracy, refer to the
PCS 7 Process Control System; 10 ms Time Stamping function manual.
5.4 How to determine the source of a message
Procedure
1. Enable the message list by clicking
2. "Activate/Deactivate Autoscroll".
Message concept of PCS 7
5.4 How to determine the source of a message
Service support and diagnostics (V8.0)
56 Service Manual, 03/2012, A5E02779775-02